Какая венецианская штукатурка есть на интернет сайте fractalis.com.ua.;термобелье купить;ремонт ноутбуков киев Restrictions while translating furnaces on a mode of a continuous fire chamberTo
convert on a continuous fire chamber gas it is possible heating furnaces of any
designs irrespective of system and furnace forms. However it is necessary to consider
a number of the restrictions connected with transfer of furnaces on a mode of
a continuous fire chamber. First, houses in which such furnaces are established,
should not have more than two floors. Secondly, оголовки chimneys of furnaces
should be deduced from a zone wind. Thirdly, to convert on a continuous mode of
a fire chamber it is possible only for the furnace small-sized and average dimensions.
Furnaces of the big dimensions (with the area of the basis more than 0,7 л2) should
be divided on two independent sections, in everyone it is necessary to establish
an independent torch. Матрацы;ремонт стиральных машин Re-equipment begin with chimney dismantling over a roof and on an attic. Further
delete latches, an outlet, зольниковую and top internal дверки, grid-irons. Zolnik
about 520 mm are extended. Flues clear of soot and building garbage and in case
of need repair. At repair full tankа apply a red brick. All apertures formed at
removal of latches and put. In зольнике on a solution establish torch АКХ-СМ-3
with a box and put an aperture of a forward wall of the furnace.
 From a
torch box delete garbage, and cracks round a torch guard cover with a lean solution.
If on furnace walls there are cracks they are carefully rubbed clean.
Above garret overlapping, beginning from fire-prevention cutting, establish
the new warmed flue. For the flue device use асбестоцементные pipes with internal
diameter 93 or 100 mm. On асбестоцементную a pipe put on sections of a metal casing
in diameter of 220 mm from the zinced roofing steel. Height of each section of
a casing of 710 mm. Space between a pipe and a casing fill теплоизоляционным with
a material (an asbestine crumb, felt). A casing fix to a roof an apron, and a
crack between an apron and a casing fill in with bitumen. On fig. 17 re-equipment
of the brick furnace on a continuous fire chamber is shown by gas. In one flue
it is possible to connect four heating furnaces converted for continuous burning
of gas. Furnaces can be connected on one and different levels, and at connection
at one level рассечку in a flue do not do. After the termination of re-equipment
the furnace and a chimney check on tightness.
|
