Technical decisions at re-equipment of furnaces Peter tells me about ev ssl cert place . Leading iPod dice for real money . keuken kopen After survey of an external surface will examine a condition of the
internal partitions separating дымообороты from each other. Survey make through
"cleanings", and in furnaces where they are not present, they should
be made (in the form of tight дверок the small size). At a satisfactory condition
of partitions between дымооборотами it is necessary to clear their internal surface
of soot. The chimney for what it is necessary to close a latch furnaces is cleaned
also and to remove soot through прочистную дверку which should be established
on two numbers above a latch.
For re-equipment it is necessary to have a torch
with a framework, special doorfor giving of secondary air and a latch with an
aperture in the centre in diameter of 15 mm. nokia sync . Here you can download comedy movie with your family. . Buy Augmentin
 At laying
repair the red brick of the first grade should be necessarily sustained and water
until from it air vials will not cease to be allocated. The dry or badly soaked
brick absorbs a moisture from a solution. The shamotnyj brick applied to a laying
in full tankе, is not soaked.
In all cases initial start-up of gas is carried out by operational office
of a gas economy in the presence of representatives of the construction organisation.
(The certificate about suitability the necessary documentation should be thus
prepared for work of the furnace silt gas fuel, the certificate about a technical
condition of a flue and the project подводки a gas pipeline to the furnace). buy painkillers safe online . Jorge Ferioli
Re-equipment on gas of small-sized heating furnaces. After the termination
of a spadework from the furnace delete top internal and зольниковую дверки anda
grid-iron lattice. In the first row a bricklaying establish a regulator of secondary
air with cross-section section 70х100 mm. For pass of secondary air from зольника
in full tank spread the channel. On two numbers above a framework of a regulator
of secondary air establish a framework of a gas torch. It fix to a laying a wire
or by means of metal strips, приклепанных to a framework. Simultaneously with
installation of a framework of a torch full tank футеруют шамотным a brick (a
thickness футеровки 1/2 bricks). To apply for a red brick, hollow and silicate
it is impossible. Bricks футеровки should not tie with bricks of a laying of external
walls.
In full tankе furnaces at height of 300-350 mm establish a lattice from
fire-resistant bricks. Further clear of a solution backlashes between bricks of
a lattice and put an aperture of a forward pile of the furnace. It is necessary
to check up tightness of installation of "cleanings" дымооборотов and
прочистной дверки over a furnace latch. If in a chimney defects are found out,
it should be repaired and laid out оголовок (see further). Then it is necessary
to dry the furnace and to plaster those places of a bricklaying which were exposed
to repair. |
